DIVERSE LOGISTICS INC.

WINDJAMMER

Maximum Onboard Memory  16MB DRAM (on optional cache controller)
Hard Drives supported   Fourteen SCSI-2 devices
Floppy drives supported None
Data Bus                External
Card Size               14cm x 23 cm
RAID levels supported   0,1

[Image]

                                CONNECTIONS

       Function          Location           Function           Location

  Proprietary              CN1        Proprietary connector       CN6
  connector - cache                   - differential
  controller                          converter board
  (optional)                          (optional)

  Proprietary              CN2        68-pin SCSI connector       CN7
  connector - cache                   to host - external
  controller
  (optional)

  50-pin SCSI              CN3        3-pin proprietary JST       CN8
  connector channel 1                 (RS-232) connector -
  -- internal                         see note below

  50-pin SCSI              CN4        Power connector             CN9
  connector channel 0
  - internal

  50-pin SCSI              CN5
  connector to host -
  external (optional)

            Note: CN8, the JST connector, can be connected to a DE-9
            serial connector using a supplied cable that performs signal
            conversion. This cable allows the Windjammer to be connected
            to a VT100/VT220 terminal or terminal emulator.

            Note: CN6 or CN7 connects the Windjammer controller to the
            host system. CN6 allows the Windjammer to interface to host
            systems with differential SCSI ports via an optional
            differential converter board.

            Note: The location of hard drive connectors differs on some
            boards. If your Windjammer version has a top cover, channel 0
            is located on the bottom of the rear panel and channel 1 on
            the top.

                         TERMINATION CONFIGURATION

      Channel          Controller Position       Termination Required

    Controller to      At end of SCSI bus      Internal host terminators
        Host                                           installed

    Controller to     Not at end of SCSI bus   Internal host terminators
        Host                                            removed

    Controller to       Active termination     Internal host terminators
        Host                required                    removed

     Channel 0         At end of SCSI bus          Channel 0 internal
                                                 terminators installed

     Channel 0        Not at end of SCSI bus       Channel 0 internal
                                                  terminators removed

     Channel 0          Active termination         Channel 0 internal
                            required              terminators removed

     Channel 1         At end of SCSI bus          Channel 1 internal
                                                 terminators installed

     Channel 1        Not at end of SCSI bus       Channel 1 internal
                                                  terminators removed

     Channel 1          Active termination         Channel 1 internal
                            required              terminators removed

           JST PINOUT

      Pin          Description

       1             Ground

       2          Receive Data

       3          Transmit Data